Cutting High Spot — Gnss Control Visual

GNSS Machine Control

GNSS machine control combines positioning, machine geometry and design information. An accurate receiver position is not automatically an accurate cutting-edge position.

Before moving material

Confirm corrections, sensor arrangement and the coordinate reference.

Receiving operation and checks

Check the completed surface with an independent method. Inspect offsets, design revision and correction status when results disagree.

Compatibility must be confirmed for the actual machine and control installation.

Dugong Working Weight & Cutting Action

Dugong working weight should be considered in relation to cutting depth, traction and the complete tractor combination. A carried load changes transport and hitch demands as well as the cutting operation.

Before moving material

Confirm current machine weight, permissible loading and tractor limits.

Receiving operation and checks

Recheck handling and receiving-surface condition as loads change. Record the actual configuration used for operating observations.

Weight and blade-pressure estimates are not a substitute for a compatibility assessment.

Dugong + GPS/GNSS Grading

Using Dugong with GPS/GNSS grading requires a complete positioning and implement-reference workflow. Antenna position must be related to the working edge and the issued surface design.

Before moving material

Confirm corrections, datum and the intended control installation.

Receiving operation and checks

Survey or otherwise independently check the resulting grade. Record interruptions and the design revision used.

A tractor's navigation system alone does not establish scraper grade-control capability.

Record the job inputs

Use this checklist to turn the scenario into a specific brief. Retain the design revision and agree who accepts each completed layer.

• Existing condition, extent and the reason for intervention
• Required finished purpose, receiving operation and acceptance criteria
• Material type, layer role, source, receiving area and volume state
• Reference levels, datum, survey method and issued design revision
• Available tractor, implement configuration, travel route and turning space
• Checks before work, stopping points and evidence retained at handover

Checklist ticks apply only while this page is open. Include the completed brief in your project records.

Continue through the network

Surface and verification · Applications and rental · Equipment and technology